Table of Contents
Advertisement
USING SETUP MODE
5-50
User's Manual
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG
Options
Items
<TEAR-EN>
(continued)
<CUTLOAD>
AUTO
BUTTON
The following <LOADTIM> item is printed when CUTLOAD:AUTO
is specified for the <CUTLOAD> item.
<LOADTIM>
0.5, 1.0, 1.5,
2.0 2.5,
3.0SEC
<DECODE>
DIRECT
QUEUED
USING SETUP MODE
Description
In some application programs, data
transfer may stop temporarily due to
internal processing. This setting can
avoid an undesired tear off feed by
waiting for up to six seconds each
time data transfer stops.
Single sheet auto loading.
Single sheet paper is automatically
loaded a certain time after you set the
paper.
Single sheet paper can be loaded by
pressing the LOAD button.
Auto load start time.
Auto loading starts when this amount
of time passes after you set single
sheet paper.
Command decode timing.
The printer decodes certain
commands immediately after
receiving data.
Example:
ESC SUB I, ESC CR
P (DPL24C+) ESC
Q # (IBM XL24E)
The printer decodes commands after
storing all data (including commands)
in the input buffer. This speeds data
reception because the printer does not
require decoding time during data
reception.
User's Manual
5-50
Advertisement
Table of Contents
