Adjustment Of The V-Belts Tension - Tar River BDR 210 Original User Manual

7.1.

Adjustment of the V-belts tension

The mower is equipped with a spring loaded belt tensioner. Correct tension of the belts can be checked
through the inspection hole (Fig. 21). Properly tightened belts should give in slightly under the pressure of
the operator's hand.
In the event of damage to, or an overextension of even one of the belts, you must always replace the entire
set of belts (using the belts with the same markings and the same brand).
B
C
D
Figure 7 Adjustment of the V-belts tension: A) Belt tensioner B) for Eco CUT 210 version
When adjusting the belt tension on the 2.10m mower (Fig. 20 B), unscrew the lock nut (Fig.
20 - C), adjust the nut closer to the spring (Fig. 20 - D), then tighten the lock nut (Fig. 20 - C)
against lock nut "D".
Figure 8 Checking of the proper adjustment of V-belts tension: 1) inspection opening for checking the tension of the belts
24