Table of Contents
Advertisement
the wrench's pressure on a holder. After replacing the holders and blades, pay attention to their proper
position on the particular discs, which is shown in the following figure.
Figure 10 Diagram of the proper mounting of holders and blades on the working discs: 1) Cutting blade,
Direction of cutting discs rotation, 3) Direction of mowing
7.3.
Maintenance after work
The machine should be washed always after work. Wash under pressure the lower part of the working
unit (holders, blades, resistance disc area), and park the machine on a flat, hard surface. Carry out an
inspection of connections between the parts and units.
Damaged and worn out parts replace with new ones. Check all the bolted joints,
tighten the loose bolts and nuts according to Table 3.
Please note:
Distributor of the machine, Tar River Equipment, provides all spare parts.
Strength
Metric thread
Table 3 Tightening torque values for bolts and nuts.
It is also necessary to check the tension of V-belts, replace the damaged ones with new (always replace the
whole set of belts). Adjust the whole set in accordance with the instruction - 7.1 Adjustment of the V-belts
tension.
Lubricate the mower according to the instruction – 7.4 Lubrication.
All safety signs placed on the machine should be kept clean.
6.8
M5
4.5
M6
7.6
M8
18
M10
37
M12
64
M14
100
M16
160
M18
220
M20
310
M22
425
M24
535
8.8
10.9
Tightening torque [Nm]
5.9
8.7
10
15
25
36
49
72
85
125
135
200
210
310
300
430
425
610
580
820
730
1050
12.9
10
18
43
84
145
235
365
500
710
960
1220
2)
26
Advertisement
Table of Contents
