Table of Contents
Advertisement
• The mower must be adjusted to working height, during its attachment to the vehicle. During the
mower operation certain adjustment is possible, it should be done from the inside of vehicle cabin,
and operator should never leave the cabin.
• Any preparations, fitting, dismantling or adjustment can be performed only after the drive has been
switched off, the engine stopped, the vehicle immobilized and when all the moving parts of the
machine have stopped.
• After first hour of operation, check the status of all separable connections, including bolts.
• The mower should be kept on a flat, level, paved surface, out of the reach of strangers and animals.
For stabilizing the mower use the support foot.
• During the fitting and dismantling of mower you should be careful, paying particular attention to the
structural elements used for fixing the mower to a vehicle.
• Before using the mower you must check the condition of mower and of the vehicle it is attached to.
The vehicle and mower unit should be in good mechanical condition. Immediately replace parts
which are worn out or damaged.
• The mower must be equipped with all the safety guards (provided by the manufacturer), preventing
access to any moving parts. The guards must be complete and fully operational.
• Work with the mower without the guards and mudguard is not allowed. Work with the damaged
guards or raised mudguard is forbidden.
• It is also forbidden to lift the mower, while the drives are working and the reels are rotating.
• It is not allowed to control the lever of hydraulic lift from outside of the tractor.
• Before beginning to work with the mower, you should familiarize yourself with the way it operates,
occupational safety rules and recommendations for maintenance and adjustment procedures, by
reading this User Manual.
• Weight of the mower suspended on a vehicle can affect the vehicle's manoeuvrability. Under these
circumstances you must exercise extreme caution.
• The User Manual should be kept on the machine. When letting the machine to other user, you must
ensure that it is in good mechanical condition, and that the User Manual is also handed over.
• It is prohibited to attach any additional means of transportation to the mower.
• During commissioning, check the machine functions and make the initial adjustments, without a load.
• Assembly protection of the three-point hitch of the mower with pins, should be made only using the
typical secure cotter pins. Using any other break-back devices is prohibited.
• Due to the natural wear, you must control the condition and completeness of the machine cutting
tools, following the instructions laid out in Chapter 7. Operation and maintenance
• On receipt of the mower after its transportation, you must make sure that the machine has not been
damaged and check its mechanical condition.
• It is forbidden to stand under the raised mower, as it may result in being crushed by the machine.
• When adjusting, do not place your fingers and limbs between the structural elements of the machine.
• It is forbidden to leave a tractor's cabin when the machine is running, and before all the rotating parts
have stopped
• Operator of the vehicle working with a mower, must ensure that no person is approaching the
machine during its operation, and the distance of not less than 50m from the working mower is
always maintained.
• Before switching on a mower's drive, lower the cutting unit to its working position.
8
Advertisement
Table of Contents
