V-Belt Tension - Tar River BDR-135 Operator's Manual

When changing the blades holders, special attention should be paid to their positional relationship between
the individual discs.
Arrangement of the Blades:
NOTE: Only certified blades should be used.

V-Belt Tension

Check the condition of the V-belt of the transmission; the flexibility under the finger pressure shouldn't exceed 1 ¼".
The V-belts are stretched with a spring tensioner (Position 1 in the drawing below). The adjustment should be made
by rotating the bolt of the tensioner. The rotating should be done with a flat wrench key, turning it on the countered
nuts M16 which are on the bottom of the bolt. In case of damaging one V-belt, a whole set of V-belts should be re-
placed.
1
V-belt tension
19