Table of Contents
Advertisement
PAIRING THE REMOTE CONTROL
TO THE APPLIANCE
Signal Code
The below operations should be carried out before coding
when changing to a new remote or the unit cannot be
controlled by the remote:
Press the power button until 2 short beeps sound from the unit,
release the button.
1
2
3 seconds
3
Within 10 seconds, press the
finished when 1 long beep sounds from the unit.
Resetting of the remote control is necessary if the
appliance operates wrongly due to external interference
signal and the remote control is not in use.
Open the back cover of the Remote.
Press the Reset button for 3 seconds and reset the coding.
40
MAINTENANCE
2 Beeps
1 Beep
button on remote. The coding is
ACCESSING THE FUEL BED
The decorative finishing trim (if installed), glass, media will need to
be removed in order to do any maintenance inside of the appliance.
THIS APPLIANCE MUST ONLY BE SERVICED BY A SUITABLY
QUALIFIED PERSON. BEFORE UNDERTAKING ANY WORK
ON THE APPLIANCE: SWITCH OFF THE APPLIANCE AND
ISOLATE THE POWER SUPPLY ENSURING THERE IS NO
POWER TO THE APPLIANCE. Wait for at least 10 minutes until
the appliance has cooled down.
1
2
3
4
Advertisement
Table of Contents
