Table of Contents
Advertisement
Owner's Information
WARNING! Do not operate the appliance if it is
damaged or has malfunctioned. If you suspect
the appliance is damaged or has malfunctioned
call a qualified service engineer to inspect the
appliance, and replace any part of the electrical
system if necessary, before reuse.
Do not disconnect the power at the mains supply while the
appliance is running. Use the functions on the remote to turn
the fire off and ensure the mains switch has been moved to
the off position before disconnecting.
MANUAL CONTROL PANEL
2 3
4
1
1. WIFI Button
2. Heater Running Indicators
3. All Lights On/Off
4. Flame Setting Button
5. Heater Button
6. Mains Power On/Off
Note: To deactivate the beeping/audible sound, press and hold in
the FLAME button (4)on the manual control panel for 3 seconds. To
reactive the beeping, repeat same steps.
OPERATING THE APPLIANCE
Press 6 to Turn the Appliance On/Off.
NOTE: To use both remote and manual functions
the manual on/off switch must be in 'ON'
position.
To prevent the product overheating, there is a
10s delay when turning on and off the heater
fan.
The manual button controls basic functions.
Use the remote hand set to carry out all functions.
Press 3 to Turn Flames and Fuel bed ON/Off at the same time.
Press 4 to select the colour of flame or return to the OFF position.
There are 3 flame colour options.
Press 5 to select the heater or return to the OFF position.
OPERATING INSTRUCTIONS
5
6
Note:
The
appliance
the light functions when the switch is set to the
Off
Position
or
the
REMOTE CONTROL
The remote control should be left on a flat surface in the
room where the appliance is installed and away from any
direct flow of hot air.
- Stand-by
Heater
-
- Flames
- Fuel Bed
- Mood Lighting Strip (Optional)
- Colour option
Levels
-
will
lose
the
memory
remote
runs
out
of
for
power.
5 5
Advertisement
Table of Contents
