How To Operate The Fluid Warmer - Enthermics EC250L Operator's Manual

How to Operate the Fluid Warmer

Before you begin
Procedure
Fl u i d W ar m er Ope r at o r' s Man u a l
▪
The warmer must be connected to electric power and turned on.
WARNING:
Do not operate the warmer in the presence of a flammable
anesthetic mixture with air, oxygen, or nitrous oxide; in
oxygen-enriched environments; or in any other potentially
explosive environment.
WARNING:
Verify the fluid temperature prior to using the fluid. Refer to the
fluid manufacturer's label for recommended warming
procedures.
Do not use any fluids that are warmed above the suggested
temperature.
Do not overload the cavity.
NOTICE
Refer to topic Specification Information for the storage cavity
capacity.
To operate the warmer, do the following.
Step Action
1. Select the operation mode.
Press the irrigation button
▪
Press
the injection button
▪
The selected operation mode will illuminate

NOTE:
from a higher temperature to a lower temperature.
2. Set the temperature using the arrow buttons

NOTE:
90°F – 150°F (32°C – 66°C).
The injection temperature set-point range is 90°F – 104°F
(32°C – 40°C).
MN -3 9 3 61 Re v 3 8 / 2 0
▪ ▪ ▪
Personal injury hazard.
Personal injury hazard.
for irrigation mode.
for injection mode.
Open the door to cool the cavity before changing
The irrigation temperature set-point range is
O
PERATION
.
.
Continued on next page
27