Table of Contents
Advertisement
Exchange and removal of frying oil / liquid fat in cubes (blocks)
1. The frying oil / liquid fat in cubes (blocks) should be replaced regularly when it
no longer fulfils legal requirements.
2. After cooling, the frying oil / fat in cubes (blocks) should be drained from the
basin via fat drain tap into a suitable container.
3. Make sure that the container is placed stably.
NOTE!
Remove used frying oil / fat with care for environment and according to
the valid regulations.
Overheating Protection System
If the fryer is accidentally switched on without frying oil / fat in cube (block), or if the
basin is filled with fat to the level below required minimum, the overheating
protection system automatically switches off the appliance. This function serves the
purpose of protecting the appliance against possible damages.
Perform the following steps:
– disconnect the appliance from mains power supply;
– contact the service company to have the appliance reset by a qualified
EN
personnel.
26 / 30
Operating Instruction
284910
Advertisement
Table of Contents
