Pair The Aircraft; Remote Control Calibration - C-Fly Faith2 Pro Operation Manual

When the antenna and the back of the remote controller have an included angle of 180 ° or
270 ° and the antenna plane is facing the aircraft, the signal quality of the remote control and
the aircraft can reach the best state.
● Please keep the aircraft flying in front of the remote control, and there are no obstacles between
the remote control and the aircraft.
● Please try to avoid the antenna tip facing the aircraft, which is in a poor communication area.
● Do not use other communication equipment in the same frequency band at the same time to
avoid interference to the remote control signal.

5. Pair the aircraft

The aircraft is pre-paired with the remote controller in the package, users can use it once turn
it on.
If the remote controller is replaced or for other reasons that causes a failure in matching the
aircraft and the remote controller, please complete the binding as the following steps :
1) Turn on the aircraft and the remote control.
2) Use data wire to connect the RC and phone.
3) Open CFLY2 APP, choose 'mine—rc paired', click 'rc paired'.
4) The Wi-Fi name scanned will be displayed in the dialog.
5) Please select the Wi-Fi of the aircraft, such as 'drone-xxxxxx' and then click 'OK'.
6) When the light of the aircraft turns green and flashes slowly or is always on, it indicates that
the RC and aircraft is paired.

6. Remote control calibration

1) Please try to calibrate RC if one of those circumstances happened:
(1) When the aircraft is under GPS mode, without any control, aircraft is drifting away to
one side.
(2) The gimbal camera automatically move without any control.
2) How to calibrate:
(1) Turn off the RC.
(2) Press the button, and hold still, then press
Attention: during this process, do not touch the left or right joystick.
(3) loose the and button, calibration is completed.
Copyright 2022 C-Fly all rights reserved
Remote Controller
to turn on the RC.
63