2 Installation
The ACTpro-1500 Controllers are for indoor installation only and must be installed as permanently
connected equipment.
After installing an ACTpro controller, Vanderbilt recommend that you place the provided ferrite bead (a
noise suppression device) around the Ethernet cable near the RJ45 connector to attain a desired level of
electromagnetic compatibility (EMC).
2.1 Mounting
Mount the ACTpro Controller directly on to the wall with the supplied screws.
The unit should be installed in a ventilated area that allows for accessibility after installation.
2.2 Power supply
The ACTpro-1500 requires an external 12V DC or 24V DC power supply. The supply should be connected
to the +12/24V DC and 0V/GND connections.
© Vanderbilt 2020
6
A-100667
18.06.2020