The Information OSD provides information such as: Monitor ID, Input Source, Picture Size, etc.
Press the DISPLAY button on the remote to bring up the Information OSD.
DVI, VGA, RGB/HV, DPORT
HDMI, DVD/HD, SCART, VIDEO1, VIDEO2, S-VIDEO
The backlight of the LCD screen can be set to increase or decrease depending on the amount of ambient light within the room.
If the room is bright, the monitor becomes correspondingly bright. If the room is dim, then the monitor will dim accordingly. The
purpose of this function is to make the viewing experience more comfortable to the eye in a variety of lighting conditions.
When picture mode is set to AMBIENT1 or AMBIENT2, BACKLIGHT, AUTO BRIGHTNESS and BACKLIGHT in
SCREEN SAVER function are disabled.
Do not cover Ambient light sensor when you use AMBIENT1 or AMBIENT2 in PICTURE MODE.
AMBIENT parameter setting
PICTURE MODE in OSD, select AMBIENT1 or AMBIENT2 and set IN BRIGHT and IN DARK in each mode.
IN BRIGHT: This is the backlight level that the monitor will go up to when the ambient light level is highest.
IN DARK: This is the level of backlight that the monitor will go down to when the ambient light level is low.
When the AMBIENT function is enabled the backlight level of the screen changes automatically according to the lighting
conditions of the room (Figure 1).
BACKLIGHT level set
for the monitor to use
when ambient lighting
level is low.
IN BRIGHT: BACKLIGHT level set for the monitor to use when ambient lighting level is high.
BACKLIGHT level set for the monitor to use when ambient lighting level is low.
ID number assigned to current monitor*
ID number assigned monitor to be controlled via RS-232C*
Audio input mode
Input Signal Information
Sub picture information
*1: "IR CONTROL" should be set "Primary" or "Secondary".
*2: "IR CONTROL" should be set "Primary".
room bright condition
Screen Backlight value by AMBIENT1 mode
Screen Backlight value by AMBIENT2 mode
BACKLIGHT level set for the
monitor to use when ambient
lighting level is high.