Display Protection - NEC MultiSync P402 User Manual

LAN SETTING When you use this function, EXTERNAL CONTROL should be "LAN".
NOTE: When changing the LAN SETTING, you need to wait several seconds until the LAN
SETTING is applied.
DHCP Enabling this option automatically assigns an IP address to the monitor from your DHCP server.
Disabling this option allows you to register the IP address or subnet mask number obtained from
your network administrator.
NOTE: Consult your network administrator for the IP address when "ENABLE" is selected for
[DHCP].
IP ADDRESS Set your IP address of the network connected to the monitor when "DISABLE" is selected for
[DHCP].
SUBNET MASK Set your subnet mask number of the network connected to the monitor when "DISABLE" is
selected for [DHCP].
DEFAULT GATEWAY Set your default gateway of the network connected to the monitor when "DISABLE" is selected
for [DHCP].
DNS PRIMARY Set your primary DNS settings of the network connected to the monitor.
DNS SECONDARY Set your secondary DNS settings of the network connected to the monitor.
SETTING COPY In a daisy chain scenario, select the OSD menu categories that you want to copy over to the
other monitor.
NOTE: When you use this function, EXTERNAL CONTROL should be "RS-232C". This function
resets to default when power is off. This function has a limit depending on the cable you use.
COPY START Select "YES" and press the SET button to start copying.
ALL INPUT All input terminals settings are copied when you select this item. Default is off.
RESET Resets "MULTI DISPLAY" options back to factory settings except LAN SETTING.

DISPLAY PROTECTION

POWER SAVE Sets how long the monitor waits to go into power save mode after the signal is lost.
Note: When connecting DVI, the video card might not stop sending the digital data even
though the image might have disappeared. If this occurs the monitor will not switch into power
management mode.
HEAT STATUS Displays status of the FAN, BACKLIGHT and TEMPERATURE.
FAN CONTROL Cooling fan reduces the temperature of the display to protect from overheating.
If "AUTO" is selected, you can adjust the start temperature of the cooling fan and fan speed.
SCREEN SAVER Use the SCREEN SAVER function to reduce the risk of Image Persistence.
GAMMA The display gamma is changed and fi xed when "ON" is selected.
BACKLIGHT The brightness of backlight is decreased when "ON" is selected.
NOTE: Do not select this function when picture mode is AMBIENT1 or AMBIENT2.
MOTION The screen image is slightly expanded and moves in 4 directions (UP, DOWN, RIGHT, LEFT) at
user determined intervals. You can set interval time and zooming ratio.
This function is disabled when PIP, STILL, TEXT TICKER or TILE MATRIX are enabled.
SIDE BORDER COLOR Adjusts the color of the side borders when a 4:3 image is displayed.
Press + button, the bar will become lighter.
Press - button, the bar will become darker.
AUTO BRIGHTNESS Adjusts the brightness level according to the input signal.
DPORT, DVI, VGA, RGB/HV inputs only
NOTE: Do not select this function when picture mode is AMBIENT1 or AMBIENT2.
CHANGE SECURITY Allows the security password to be changed.
PASSWORD The factory preset password is 0000.
SECURITY Locks the security password.
DDC/CI ENABLE/DISABLE: Turns ON or OFF the two way communication and control of the monitor.
ALERT MAIL Selects whether or not to send an e-mail notifi cation of monitor error via wired LAN.
RESET Resets the following settings within the DISPLAY PROTECTION menu back to factory
setting: POWER SAVE, FAN CONTROL, SCREEN SAVER, SIDE BORDER COLOR, AUTO
BRIGHTNESS, DDC/CI.
English-24
DISABLE
192.168.0.10
255.255.255.0
192.168.0.1
0.0.0.0
0.0.0.0
NO
-
ON
-
AUTO
OFF
OFF
OFF
15
OFF
-
OFF
ENABLE
OFF
-