Power consumption under 0.5 W*
Power consumption under 1 W*
Power Standby when "SCHEDULE
Diagnosis (Detecting failure)
*1 If "OFF" is selected in POWER INDICATOR (page 23), the LED will not light when the
LCD monitor is in active mode.
*2 Without any option, with factory settings, VGA input only
Using Power Management
The LCD monitor follows the VESA approved DPM Display
Power Management function.
The power management function is an energy saving
function that automatically reduces the power consumption
of the display when the keyboard or the mouse has not been
used for a ﬁ xed period.
The power management feature on your new display has
been set to the "ON" mode. This allows your display to
enter a Power Saving Mode when no signal is applied. This
could potentially increase the life and decrease the power
consumption of the display.
Depending on the PC and video card used, this
function may not operate.
It takes about 10 minutes for the monitor to go into
power management mode when using DVD/HD,
SCART, VIDEO1, VIDEO2 and S-VIDEO.
Selecting a video source
To view a video source:
Use the input button to set [VIDEO1], [VIDEO2], [S-VIDEO].
Use the COLOR SYSTEM menu to set [AUTO], [NTSC],
[PAL], [SECAM], [PAL60], [4.43NTSC], according to your
Status Indicator Light
Green and Amber blink alternately
(See Troubleshooting page 36)
DVI, VGA, RGB/HV, DPORT
HDMI, DVD/HD, SCART, VIDEO1, VIDEO2, S-VIDEO
Grey areas indicate unused portions of the screen.
NORMAL: Displays the aspect ratio the same as it is sent
from the source.
FULL: Fills entire screen.
WIDE: Expands a 16:9 letter box signal to ﬁ ll entire screen.
DYNAMIC: Expands a 4:3 pictures to ﬁ ll the entire screen
with non-linearity. Some of the outside image area will be cut
off due to expansion.
1:1: Display the image in a 1 by 1 pixel format.
The image can be expanded beyond the active display area.
The image which is outside of active display area is not
for picture aspect*