Fluid Section, Model F100 (Catalyst) (Refer To Doc. 573.114.050) - SAMES KREMLIN PU3000 2L 53/1 Translation From The Original Manual



FLUID SECTION, MODEL F100 (CATALYST) (REFER TO DOC. 573.114.050)

Guards (air motor cover, coupling shields, housings ...) have been designed for
safe use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.
1 - DISASSEMBLY / ASSEMBLY OF THE FLUID SECTION PART
Unscrew the fitting nut (38) and the screws (41 and 43) to remove the connection tube (39).
SUCTION VALVE
Unscrew the suction valve (35) holding the cylinder (27).
The ball (22) is secured on the valve (35) by means of a circular rush (21).
Clean the parts.
Reinstall the suction valve (35) and the seal (23) changing parts if necessary.
EXHAUST VALVE AND MOBILE PACKING
Unscrew the cylinder (27) and pull it downwards.
Unscrew the exhaust valve (34) holding the piston (24).
Remove the ball (32) and mobile packing (GT seal - ind. 31).
Clean the parts and reinstall them. Replace seals if necessary.
UPPER TIGHTNESS SEAL
Unscrew the 4 screws (30).
Remove the tightness seal (28) pulling discharge flange (25) downward.
Change the tightness seal (28), the O-Rings (29 and 11).
Reinstall the parts in the reverse order of the disassembly sequence.
2 - DISASSEMBLY - ASSEMBLY OF THE COUPLING (WITH BELLOWS)
That operation must be carried out after the disassembly of the fluid section part.
BELLOWS
Unscrew the nuts (14) from the coupling tie-rods.
Take off the suction flange (1) and the cylinder (2) pulling them downwards.
Remove screws (12) to separate the suction bearing (3) from the motor.
Separate the intermediate piston (9) from the motor rod.
Put aside the coupling with bellows assembly.
Disassemble the bellows' flange (4) removing the screws (13) to take off the upper part from the
bellows.
Unscrew the skirt (8) to take off the lower part from the bellows.
Change the bellows (5).
Install the new bellows pushing it into skirt (8) firmly.
Insert the intermediate piston (9) inside the bellows (5) and screw the skirt at its end.
Insert the bellows and the piston (9) into the bearing (3).
Install the flange (4) into bellows (3) and tighten the whole with the screws (13).
Connect bellows-piston assembly with the motor rod and secure it to the lower support of the
motor with the screws (12).
Reinstall the fluid section piston (24) on the intermediate piston (9).
Change the seals (11) then reinstall the cylinder (2) and the suction flange (1).
Install the whole on the tie-rods and tighten the nuts (14).
SAMES KREMLIN Page 49 Manual : 573.199.112