Table of Contents
Advertisement
IFU-TL HR GB.fm Page 17 Friday, November 7, 2008 2:30 PM
Adjust the feet
Install the washing machine on a level surface, near to
electrical, water and drain connections.
If the floor is uneven, adjust the feet (do not insert pieces of
wood, cardboard etc. under the feet):
1. Loosen the locknut using the wrench provided.
2. Adjust the height of the feet by hand.
3. Retighten the locknut by turning it anti-clockwise.
Make sure that the feet are resting correctly on the
floor and that the washing machine is perfectly level
and stable (use a spirit level).
The washing machine can be installed in an area 40 cm wide
and 63 cm deep.
Note: if you install the machine on thick carpet, adjust the
feet to ensure that there is sufficient space under the
machine for the air to circulate.
Connect the water inlet hose
1. Carefully screw the water inlet hose "A" (see pictures 1,
2 or 3, depending on the model) onto the tap by hand.
2. Make sure there are no kinks in the hose.
3. Check water-tightness of tap and washing machine
connections by turning the tap completely on.
It the hose is too short, replace it with a suitable hose
available through our After-Sales Service or your specialist
retailer.
Periodically check the hose for brittleness and cracks.
Replace it if necessary by a new hose available through our
After-Sales Service or your specialist retailer.
The washing machine can be connected without a non-
return valve.
Black process 45.0° 100.0 LPI
GB 17
A
1
2
3
Hide quick links:
Advertisement
Table of Contents
