Whirlpool AWE 6517 Instructions For Use Manual page 14

IFU-TL HR GB.fm Page 14 Friday, November 7, 2008 2:30 PM
Red indication lamp
lights up
"Service"
If your washing machine has no time display, check which of the previously described
situations could be the origin of the fault and follow the corresponding instructions.
Black process 45.0° 100.0 LPI
Indication on display
(if fitted on your
machine)
"bdd" Appliance stops during the programme.
(in case your washing
machine has no
"Drum flaps open" (the drum flaps have not been
display: all lamps of the
closed properly).
programme sequence
Push the "Reset" button
indicator light up)
and wait until the "Door open"
lid and close drum flaps, then select and start
desired programme again. If fault persists, notify our
After-Sales Service.
from "F02" to "F35" "Electrical module fault"
(except "F09")
Select and start "Drain" programme or push
"Reset" button
"F09" "Water level too high" (after programme
cancellation or false operating). Switch off appliance
and then switch it on again, select programme
"Drain" and start within 15 sec.
"FA" "Waterstop fault"
Switch off appliance, pull out mains plug and turn
water tap off. Tilt appliance forward carefully to
allow collected water to flow out from the bottom.
Then:
• Plug in the appliance again.
• Turn the water tap on (if water immediately flows
into the appliance without the appliance being
started, there is a failure; turn off the tap and notify
After-Sales Service).
• Select and start the desired programme again.
"Fod" "Overfoaming"
Too much foam interrupted the wash programme.
• Select and start "Rinse & Spin" programme
• Afterwards select and start desired programme
again, using less detergent.
If faults persist, unplug the appliance, turn off the
water tap and contact our After-Sales Service (see
next chapter).
GB 14
Description
Causes
Solutions
for at least 3 seconds
lights up. Open
for at least 3 seconds.
.