Using The Headphone Output - SIGNIFY EA2327 Instruction Manual

Instructions (cont.)
IMPORTANT: Before playing music from a micro SD card, turn down the volume of the Radio to avoid a
possible loud output from the speakers. Wait until the music is playing and then turn up the volume.
NOTE: Before removing the micro SD card from the Radio, we recommend that you turn the Radio OFF first
by sliding the ON/OFF switch (located on the back of the Radio) to the OFF position.

Using the Headphone Output

The Radio features one 3.5mm headphone output (located at the back of the Radio) which allows you to listen
to the Radio through headphones (not supplied) instead of the Radio speaker. This is a useful feature if you
do not want to disturb others while listening to the Radio. Simply connect the headphones to the headphone
output and the Radio will now divert the audio through headphone output instead of the Radio speaker.
NOTE: If the headphones/earphones are not properly connected to the headphone output then the audio
will continue to play through the Radio speaker.
NOTE: When listening to tracks via the headphone output, always be aware that you may need to adjust
the volume on both the Radio and the headphones to reach the required volume.
NOTE: Do not turn the VOLUME control dial in an extremely fast motion. It is best to turn it slowly for more
accurate volume control selection.
IMPORTANT: If the volume of the Radio is more than 5 bars and headphones (not supplied) are connected to the
Radio for the first time, then the volume of the Radio will automatically adjust to the recommended volume of 5
bars. At this stage, you can turn down the volume of the Radio by turning the VOLUME control dial anticlockwise.
To increase the volume, turn the VOLUME control dial clockwise until 'Warning, unsafe volume! OK?' displays on
the LCD display screen, then short press the ENTER button and proceed with turning the volume dial clockwise.
If the volume is turned down below 5 bars the Radio will reset the maximum volume to 5 bars and each time the
VOLUME dial is turned to above 5 bars, 'Warning, unsafe volume! OK?' will display on the LCD display screen, and
you will need to short press the ENTER button once again. This is a safety feature and not a product fault.
NOTE: If you are listening to the Radio using headphones at a volume of 6 bars or higher continuously for 18 hours
then the Radio will automatically readjust the volume to 5 bars. This is a safety feature and not a product fault. To
increase the volume once again, turn the VOLUME control dial clockwise until 'Warning, unsafe volume! OK?' displays
on the LCD display screen, then short press the ENTER button and proceed with turning the volume dial clockwise.
High sound pressure with hearing damage risk. Do not listen at high volume levels for long periods.
IMPORTANT: It is NOT recommended to increase the volume higher than 5 bars when listening to audio
via headphones connected to the Radio. Listening to audio via headphones at a higher volume than
recommended may cause damage to your hearing.
AFTER SALES SUPPORT
1300 777 137
26
MODEL: EA2327 PRODUCT CODE: 712283 04/2023
service@unclebills.com.au