Table of Contents
Advertisement
H. Wiring the Proximity Card Reader
VIKING
* Note: Up to 500 ft Wiegand cable run length can be achieved using Belden 9537 or equivalent 24 AWG stranded shielded
cable. Longer cable runs up to 10,000 ft can be achieved by using a Wiegand card reader extender. For more information, go
to: www.cypressworld.com
A. Adjusting Speaker Volume
The speaker volume pot can be adjusted to increase or decrease the speaker volume to the level
desired.
B. Adjusting the Microphone Volume
In certain noisy locations (background traffic, machinery or wind), the microphone volume may need
to be decreased. A symptom of this is one-way talk path, in which the distant party cannot be heard
over the speaker. A microphone volume pot is provided for increasing or decreasing the microphone
volume. Note: If the microphone volume is set too high or too low, one-way talk path may occur.
Microphone
Volume
(see section B)
DIP
Switches
ON
ON
OFF
1
2
3
Back View of the E-75 Circuit
Board Mounting Plate
3-Wire Gel-Filled Butt
Connectors included
(3M Scotchlok UR2)
- Black (GND)
Black
+ Red (5-14VDC)
Red
Green (Date 0)
Green
White (Data 1)
White
VIKING
4
Doorstrike
Power Supply
5A@30VDC/250VAC
maximum
(not included)
(Power typically
not required for
gate controllers.)
Doorstrike/Magnetic Lock
24 Awg Stranded
Shielded Cable
(Belden 9537)
Up to 500 ft
Remote Touch Tone
RAD-1A Remote Access
Programming Phone
Device (not included)
Programming
Viking Model ES-1 (not included,
see DOD# 193 for more information)
VIKING
12V DC
Adapter
Included
DOOR CONTROLLER
or
(not included)
Black
To Viking model
Red
Green
Equivalent 26-Bit
Wiegand Card
White
Reader Controller
Local Touch Tone
Programming Phone
or
(see section A)
Rear View of the
E-75 Circuit Board
Mounting Plate
MODEL ES-1
©
VIKING
ELECTRONICS
HUDSON, WI 54016
STAND ALONE
ENTRY SYSTEM
1
2 3 4 5 6 7
8 9 10 11
ES-1 or
Speaker
Volume
7
Advertisement
Table of Contents
