Table of Contents
Advertisement
Faceplate: 18 guage 304 stainless steel with
super durable UV stable powder paint to
prevent fading and resist scratching.
Color Video Camera:
Wide operating
temperature range of -30°F to 150°F, NTSC
composite video output with 420 lines of
resolution, 80° wide viewing angle lens, tilt and
swivel adjustments for aiming towards visitors.
Impact resistant polycarbonate lens with scratch
resistant coating and water-tight gasket.
Proximity Card Reader:
26-bit Wiegand,
125KHz, red LED turns off and transducer will
beep during card read. Fully potted EWP. Read
range
1.25"
to
2.0".
Impact
polycarbonate lens with water-tight gasket.
Entry Phone Board: Compact analog speaker
phone with call progress detection for automatic
disconnect.
Microphone Volume
Speaker Volume
Earth Ground: To increase surge protection,
loosen the screw labeled
fasten a wire with ring terminal (included) from
the mounting screw to Earth Ground (grounding
rod, water pipe, etc.)
The E-75 is designed to be flush mounted into a standard double gang rough-in box with minimum
inside dimensions of 2.25" deep x 3.65" wide x 2.84" tall. The E-75 can also be surface mounted in a
Viking model VE-5x5 (not included, see DOD 424).
WARNING: Do NOT use a typical "wet location box" as not all styles seal properly with the E-75
faceplate.
A. New Construction Flush Mounting
Recommended mounting heighy to bottom of the rough-in box is 50" - 54". Front of box
should stick out approximately ½" from front surface of wall stud (this may vary depending
Step 1
on the walls sheathing and siding thickness). Caution: Rough-In box must be mounted
LEVEL and must NOT stick out beyond the front surface of siding.
To maintain a vapor barrier on outside wall applications, caulk around the box, filling any
Step 2
gaps between the box and the rough opening. Apply caulk to any holes in the box around
wires, etc.
When installing siding cut a hole just large enough for the Rough-In box opening.
Caution: Too large of a hole can cause plate misalignment and compromise the gasket
Step 3
seal. Note: A siding mounting block is recommended when mounting to vinyl siding or
siding with a 4 inch or less horizontal lap. Contact siding installer for the correct mounting
block.
Features Overview
resistant
VIKING
VIKING
(as shown) and
Installation
Speaker Screen: Fiberglass Reinforced Plastic
speaker screen with 0.028" slots to prevent
punctures from paperclips, etc.
Speaker: Mylar speaker with rubber gasket to
maintain water-tight seal and eliminate water
deterioration.
Blue LED:
Helps locate the push button,
indicate ringing and off-hook conditions.
Push Button Switch:
Push to initiate call,
push again to disconnect. Solid 304 stainless
steel internally sealed per IP67.
Microphone:
Omni-directional microphone
with protective water-resistant cloth.
Mounting Screws: 6-32 x 1.25" long flathead
with 5/64" hexdrive, 18-8 stainless steel to
prevent corrosion.
Faceplate Gasket: 1/8" thick closed cell PVC
to provide a water-tight seal.
DIP Switches (see page 6):
1: Auto Answer Feature (on/off)
2: Dial Tone Detection (on/off)
3: Programming Switch (normal/programming)
4: LED (on/off)
3
Advertisement
Table of Contents
