Adjusting The Camera; Dip Switches; Volume Adjustments - Viking K-1775-3 Series Product Manual

C. Using a Video Encoder to Convert the Analog NTSC Video to IP
Axis manufactures video servers that encode analog video signal for
transmission across IP network or the internet. The single channel model M7011
is shown. Supplied software allows you to access Axis units connected to the
network (auto-discovery) and program them via a web page interface. The video
can then be monitored from any location on the network.
For more information, go to www.axis.com
D. Adjusting the Camera
The camera can be tilted and rotated to
your desired position. A portable service
(test) monitor can be used to determine the
correct viewing angle during installation.
Important: To prevent the edge of the
faceplate from being viewed in the video
image, do not rotate the camera beyond 30
degrees or tilt beyond 20 degrees.
A. DIP Switches
Switch 1 Switch 2 Maximum Call Time
OFF OFF
ON OFF
OFF ON
ON ON
Switch 3 Disconnect on Dial Tone
OFF Off
ON On(default)
Switch 4 VOX Switching Speed
OFF Fast, 0.2 sec. (default)
ON Slow, 0.7 seconds
Switch 5 Switch 6 Audio Detection
ON ON
OFF OFF
Switch 7 Auto Answer Position
OFF Automatic answer disabled
ON Automatic answer enabled (default)
Switch 8 Push Button Feature
OFF Connects calls only
ON Connects/disconnects c alls (default)
B. Volume Adjustments
1. Microphone
Certain noisy locations (background traffic, machinery or wind) may cause one way talk path (only microphone audio is heard).
In this case, the microphone volume may need to be decreased as shown.
2. Speaker
To increase, decrease or turn off the speaker (for monitoring purposes only), adjust the speaker volume control as shown.
+/- 20 degrees
Programming
Disabled (default)
1 Minute
3 Minutes
9 Minutes
Normal Audio detection
Increase audio detect sensitivity for
low level lines. Useful in applications
in which voice or busy signals have
trouble breaking over the speaker.
Horizontal (Rotation)
Adjustment
+/- 30 degrees
maximum
Vertical (Tilt)
Adjustment
maximum
Rear View of
the K-1775-3
(shown in default
5
Axis Model
M7011 shown
1 2
ABC
4 5
GHI JKL
7 8
PRS TUV
0
OPER
Microphone Volume
(see section B)
OFF

DIP Switches

positions)
ON
3
DEF
6
MNO
9
WXY
#
VIKING
©
Speaker Volume
(see section B)
OFF
8
7
6
5
4
3
2
1
OFF