Table of Contents
Advertisement
www.ti.com
1 High-Density EVM Description
The TLVM13610EVM features the TLVM13610 synchronous buck power module configured for operation with
typical 3-V to 36-V input bus applications. This wide-V
operating margin to withstand supply-rail voltage transients.
The output voltage can be set to either 3.3 V or 5 V and switching frequency can each be set to one of five
popular values (400 kHz, 700 kHz, 1 MHz, 1.4 MHz, and 2.2 MHz) by using configuration jumpers. Additionally,
a resistor placeholder footprint is on the backside of the EVM to allow adjustment of the switching frequency
outside of the five jumper settings.
The EVM provides the full 8-A output current rating of the device. The selected input and output capacitors
accommodate the entire range of input voltage and the selectable output voltages on the EVM and are available
from multiple component vendors. Input and output voltage sense terminals and a test point header facilitate
measurement of the following:
•
Efficiency and power dissipation
•
Line and load regulation
•
Load transient response
•
Enable ON, OFF
•
Bode plot (crossover frequency and phase margin)
PCB layout
maximizes thermal performance and minimizes output ripple and noise.
1.1 Typical Applications
•
Test and
measurement,
•
Factory automation and
•
Inverting buck-boost (IBB) circuits
SLVUCN1 – JANUARY 2023
Submit Document Feedback
aerospace and defense
control,
power delivery
requiring negative output voltage
Copyright © 2023 Texas Instruments Incorporated
range DC/DC solution offers outsized voltage rating and
IN
TLVM13610EVM Buck Regulator Evaluation Module
High-Density EVM Description
3
Advertisement
Table of Contents
Need help?
Do you have a question about the TLVM13610EVM and is the answer not in the manual?