Table of Contents
Advertisement
6.4.2
Gasket
It is important to replace the gasket with another having the
same diameter and density to maintain a good seal.
1.
Remove the door and place it face-down on something soft
like a cushion of rags or a piece of carpet.
2.
Remove the old gasket from the door. Use a screwdriver to
scrape the old gasket adhesive from the door gasket groove.
3.
Apply a bead of approximately 3/16" (5 mm) of high
temperature silicone in the door gasket groove. Starting from
the middle, hinges side, press the gasket into the groove.
The gasket must not be stretched during installation.
4.
Leave about ½" (13 mm) long of the gasket when cutting and
press the end into the groove. Tuck any loose fibers under
the gasket and into the silicone.
5.
Close the door. Do not use the stove for 24 hours.
DOOR ALIGNMENT
6.4.3
Door Alignment
To align, open the door and loosen the pressures screws located on the lower and upper hinges o
To align, open the door and loosen the pressures screws located on the lower and upper hinges of the
door using a 3/32" Allen key to free the adjustable hinge rods.
door using a 3/32" Allen key to free the adjustable hinge rods.
Using a flat screwdriver, turn the adjustable hinge rods in the direction shown to adjust the doors. Ti
Using a flat screwdriver, turn the adjustable hinge rods in the direction shown to adjust the doors.
all door hinge pressure screws when they are at the desired positions. Configurations 1-2-3-4-5-6,
Tighten all door hinge pressure screws when they are at the desired positions. Configurations 1-2-3-
in which direction these act on the adjustment of the door
4-5-6, show in which direction these act on the adjustment of the door.
Page 24
3/32"
Installation and Operation Manual - Solution 3.3
Advertisement
Table of Contents
