Important
• When using an AC power supply, use the attached AC adapter.
• When using a DC power supply, use the attached DC cable.
• When the product to connect via network or connect with an Air Particle Sensor
(ZN-PD-S), Supply the power with the AC adaptor or DC power supply.
Note
The main unit does not have a power supply button. When supplying the power to the
product, the Air Thermo Station starts operation immediately.
AC adaptor/DC power supply has priority when connecting AC adaptor or DC power supply
as using a battery in the product. When supplying power has stopped due to a power failure,
it will be automatically switched to battery power if mounted.
(2) When using batteries
Important
When inserting the batteries, be careful about the direction of the polarity. Inserting the
battery with wrong polarity may result in damage of the main unit.
Use two batteries of the same type. Do not mix the old and new batteries.
When using the product via network connection or connecting it with an Air Particle Sensor
(ZN-PD-S), the battery life is approximately 2 hours (for 10-minute measurement
intervals and using nickel metal hydride batteries). Supply the power with the AC adaptor or
the DC power supply.
[1] Slide to open the battery cover on back of the
main unit.
[2] Insert two batteries with careful attention to
proper polarity.
[3] Slide to close the battery cover.
3-4
3. Check and Preparation