Table of Contents
Advertisement
The following item appears when the ▼ key is pressed after the setting is applied with the
SET/REC/STOP key.
Setting Value
OFF
TIME
Initial value:
OFF
Note
ETC returns to OFF after restarting.
(7) Reading setting data (RESTR)
Restore the settings of the main unit by using SD memory card in which the setting data has
been saved as a backup with BCKUP (described later).
Operation:
Insert the SD memory card in which the setting data has been saved, and hold the
SET/REC/STOP key. Reading completes when "DONE" is displayed.
When pressing the MODE key to change the operation mode, the unit will be reset and
restarted.
Note
The number of the setting data items that can be stored in one SD memory card as a
backup is one for a unit. The setting data that has been backed up with a unit can be
restored with another unit.
When ETC is OFF, the setting data cannot be read.
(8) Writing the setting data (BCKUP)
Saves the setting data of the Differential Pressure Station unit into the SD memory card.
Operation:
Insert an SD memory card and hold the SET/REC/STOP key.
Saving is complete when "DONE" is displayed.
Important
The number of the setting data items that can be stored in one SD memory card as a
backup is one for a unit.
When performing a backup using the SD memory card in which the setting data has already
been backed up, the setting data will be overwritten. The data will also be overwritten if a
backup is performed on another unit.
Note
• The setting data is written into the system folder of the SD memory card.
When ETC is OFF, reading of the setting data cannot be performed.
(9) Setting time (TIME)
Specifies the time setting.
Item
CYCLE
RESTR
4-8
4. Setting the Unit (Unit Operation)
Advertisement
Table of Contents
