Electrical Installation - Siemens SINAMICS V60 Getting Started

Controlled power module

Hide thumbs Also See for SINAMICS V60:

Table of Contents

Note

For motors with keys, the flat key size is as shown in the above figure.

For the key way size, refer to the national standard GB/T 1095-2003

For the flat key size, refer to the national standard GB/T 1096-2003 (key C 8X7X40)

Mounting orientation and ingress protection requirements

You can mount a motor vertically or horizontally. Make sure that no fluid (water, oil, etc.) can penetrate into the motor while

installation or motor operation. Keep the cable outlet pointing downwards if a motor is mounted horizontally, in order to

protect the motor from ingress of oil or water.

2.2

Electrical installation

Connecting the drive with the SINUMERIK 808D CNC Controller

For a turning variant, the SINUMERIK 808D is designed to control three axes, including two feed axes (connected with the

SINAMICS V60) and one spindle. For a milling variant, the SINUMERIK 808D is designed to control four axes, including

three feed axes (connected with the SINAMICS V60) and one spindle. The connection diagram below takes interface X51

(axis X) for example to show you a system connection between the SINAMICS V60 and the SINUMERIK 808D.

Controlled Power Module (CPM60.1)

A5E03975175-002, 04/2014

Table of Contents

Cpm60.1