Table of Contents
Advertisement
Changing Embroidery Foot "W+" with LED
Pointer
CAUTION
• When attaching an embroidery foot, always
touch
on the screen. You may
accidentally press the "Start/Stop" button and
possibly cause injury.
• Be sure to use the embroidery foot "W+" with
LED pointer when doing embroidery. Using
another embroidery foot may cause the needle
to strike the embroidery foot, causing the
needle to break and possibly causing injury.
a
Press
(Needle position button) to raise the needle.
b
Touch
to lock all keys and buttons.
*
If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, touch
to continue.
Note
• Before replacing the needle, cover the hole in the
needle plate with fabric or paper to prevent the
needle from falling into the machine.
c
Raise the presser foot lever.
d
Remove the connector of the embroidery foot "W+"
with LED pointer from the connector on the back of
the machine.
e
Use the included disc-shaped screwdriver to loosen the
screw for the embroidery foot, and then remove the
embroidery foot "W+" with LED pointer.
a
1 Screw for embroidery foot
CARE AND MAINTENANCE
f
Position the embroidery foot "W+" with LED pointer
on the presser foot bar by aligning the notch of the
presser foot to the large screw.
Side view
g
Hold the embroidery foot in place with your right
hand, and then use the disc-shaped screwdriver to
securely tighten the screw for the embroidery foot.
a
1 Screw for embroidery foot
CAUTION
• Use the disc-shaped screwdriver to firmly
tighten the screw for the embroidery foot. If
the screw is loose, the needle may strike the
embroidery foot and break, possibly cause
injury.
h
Plug the connector of the embroidery foot "W+" with
LED pointer into the jack on the back left side of your
machine.
i
Touch
to unlock all keys and buttons.
All keys and operation buttons are unlocked, and the
previous screen is displayed.
5
111
Advertisement
Table of Contents
