Checking The Needle Drop Point With Led Pointer; Turning The Led Pointer "On" Or "Off - Brother PR655 Operation Manual Addendum

Checking the Needle Drop Point with LED Pointer

The LED pointer shows you the location of the
needle penetration so that it is easier to adjust the
embroidery position.
1 Needle drop point
The LED pointer turns on automatically while the
embroidering screen appears, and it turns off when
you start embroidering. You can set the LED pointer
function on or off in the settings screen.
Note
● The LED pointer may not be available
depending on the type of embroidery
frame attached.
● With fabric that has a very uneven or
textured surface, the position of the LED
pointer may not be correctly aligned. In
this case, the pointer indication should be
used only as a reference.
Turning the LED pointer
"ON" or "OFF"
1 Press .
2 Display page 4 of the settings screen.
3 Press to turn on the LED pointer to
check the needle drop point.
The key appears as
selected, and it appears as
"OFF" is selected.
* Each touch of the key turns the setting either on or off.
2
when "ON" is
when