Internal Termination - Peak PCAN-USB Pro FD User Manual

2.3 Internal Termination

The termination can be activated by solder jumpers on the circuit board, to
terminate one end of the CAN bus. At delivery the termination is not activated.
Tipp: We recommend to do termination at the CAN cabling, for
example with the terminating resistors PCAN-Term (IPEK-003002) or
PCAN-MiniTerm (IPEK-003002-Mini). Thus, CAN nodes can be flexibly
connected to the bus.
For PCAN-USB Pro FD from S/N 24548
Set the solder bridges corresponding to the desired settings.
D-Sub connector
CAN 1
CAN 2
2 Configuration PCAN-USB Pro FD
User Manual 2.0.0 © 2023 PEAK-System Technik GmbH
Solder field Termination
(Standard)
Term.
Term.
Without Active
13