Open The Casing - Peak PCAN-USB Pro FD User Manual

2.1 Open the Casing

1. Remove the three screws at the back of the casing.
2. Remove the two outer screws next to the D-Sub connectors at the front of the
casing.
3. Remove the casing cover.
4. Lift the back of the case and slide the circuit board in direction of the front over
the lower part of the casing.
5. When you have finished the configuration, close the interface.
Close interface
1. Slide the circuit board back into the lower part of the casing.
2. Close the casing cover.
3. Tighten the screws at the front and back side.
2 Configuration PCAN-USB Pro FD
User Manual 2.0.0 © 2023 PEAK-System Technik GmbH
10