Device Settings; Sensors; Load - Siemens WN34A100EU Manual

NL

Device Settings

Always wait for the program to
■
finish. The device may still be
locked. Then turn on the device and
wait for it to unlock.
Q
Device Settings
You can make the following settings
Device Settings
we
zigen:
The volume of the final signal. The
■
volume of the key signal. Switch the
■
drum care information signal on/off.
■
You must enter setup mode to be able
to change these settings.
1/2/3/4... stands on the
program selector
To activate setup mode:
1. Set the program selector to position 1.
The appliance is switched on.
2. touch the 0 Spin Speed (Center
Speed Selection) button on hold
pressed it and at the same time turn
the program selector clockwise to
position 2. Release the 0 Spin Speed
(Center speed selection) release button.
The setting mode is activated and the
preset appears on the display panel.
44
Volume and
change drum care information
Use the B Finish in/Time Dry button
to the
following settings at the
corresponding
to change program selector positions:
2: The volume of the final signal. 3: The
■
volume of the button signals.
■
0 = off, 1 = silent,
2 = medium, 3 = loud, 4 =
very loud
4: Switch the drum care information
■
signal on/off.
Ž at
Πfrom
Exit setting mode
You can now end the process and open
the program selector in the (From)
position. The settings will be
stored.
huh

Sensors

Unbalanced load detection system
Sensors
The automatic unbalance loading system
detects an imbalance and ensures an even
distribution of the laundry by repeatedly
starting and stopping the drum spin.
If the laundry is extremely unevenly
distributed, the spin speed will be reduced
or the spin will not be stopped at all
performed for security reasons.
Note: Distribute small and large items
of laundry evenly in the drum.