Configuration - HORNER APG EXL10 OCS User Manual

7.4

Configuration

An overview of configuration:
1. Start the configuration by selecting the Controller → Hardware Configuration menu item.
2. If the EXL10 OCS is connected to the PC press the Auto Config System button to automatically
detect the Base model, I/O and any communication options.
3. If the EXL10 OCS is not connected press the Config button to the right of the top of the unit. This
allows the base CPU to be selected.
4. Select either EXL10 OCS CsCAN from the type drop down box.
5. Once the type of EXL10 OCS is selected, the model # drop down box will provide the EXL10 OCS
model numbers from which to choose from.
6. Once the EXL10 OCS CPU is selected, press OK to exit the dialog and configure the I/O that is
present in the first slot.
7. The I/O configure dialog (Specifically the Module Setup tab) provides four (4) buttons to
configure all of the I/O. Go through each area of I/O and configure it.
8. Once done configuring the I/O, OK out of configuration dialogs.
Configuring the EXL10 OCS I/O has four main portions that are covered in this chapter. For additional
information on I/O, refer the chapters covering General I/O or High-Speed I/O in this manual.
The four areas of I/O configuration are:
Digital in / HSC
-
Digital out / PWM
-
Analog in
-
Analog out
-
t h
A p r i l 2 4 , 2 0 2 0
MAN1029-08-EN_EXL10_UserManual
P a g e 66 | 191