Chapter 1: Safety / Compliance; Safety Warnings And Guidelines - HORNER APG EXL10 OCS User Manual

CHAPTER 1:
1.1

Safety Warnings and Guidelines

When found on the product, the following symbols specify:
Warning: Consult user documentation.
WARNING – EXPLOSION HAZARD – Do not disconnect equipment unless power has been switched off
or the area is known to be non-hazardous
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth) ground
before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly recommended to
fuse the voltage measurement inputs. Be sure to locate fuses as close to the source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of fire and
shock hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure
indicates a defective condition that will not clear by replacing the fuse.
WARNING – EXPLOSION HAZARD – Substitution of components may impair suitability for Class I,
Division 2
WARNING: The USB parts are for operational maintenance only. Do not leave permanently connected
unless area is known to be non-hazardous
WARNING – EXPLOSION HAZARD - BATTERIES MUST ONLY BE CHANGED IN AN AREA KNOWN TO BE
NON-HAZARDOUS
WARNING: Battery May Explode If Mistreated. Do Not Recharge, Disassemble or Dispose Of In Fire
WARNING: Only qualified electrical personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, or service this equipment. Read
and understand this manual and other applicable manuals in their entirety before proceeding. Failure
to observe this precaution could result in severe bodily injury or loss of life.
t h
A p r i l 2 4 , 2 0 2 0
SAFETY / COMPLIANCE
MAN1029-08-EN_EXL10_UserManual
Warning: Electrical Shock Hazard.
P a g e 10 | 191