Ethernet Module Configuration - HORNER APG EXL10 OCS User Manual

12.4 Ethernet Module Configuration

NOTE: The following configuration is required for all applications regardless of the protocols used.
Additional configuration procedures must be performed for each protocol used.
To configure the Ethernet Module, use Cscape Programming Software to perform the following steps
On the main Cscape screen, select the Controller → Hardware Configuration sub-menu to
1.
open the Hardware Configuration dialog (Figure 12.1).
2. If configuring a different OCS Model than the one shown in the Hardware Configuration
dialog, click on the topmost Config button, select the desired OCS Model, and then click OK.
3. Click the Config button to the right of LAN1 for LAN 1 or LAN2 for LAN2, revealing the Ethernet
Module Configuration dialog as shown in Figure 12.2.
t h
A p r i l 2 4 , 2 0 2 0
Figure 12.1 – Hardware Configuration Dialog
MAN1029-08-EN_EXL10_UserManual
P a g e 112 | 191