Establishing Communications - HORNER APG EXL10 OCS User Manual

7.3

Establishing Communications

The EXL10 OCS can communicate with Cscape using USB to USB, USB to serial adapters, serial port
communications via MJ1 Port and MJ3 Port, Ethernet, onboard Ethernet Ports, CAN (CsCAN), or
modems.
If a direct USB connection is to be used, connect the Mini-USB port on the OCS (only on select models)
to an open USB port on the PC. (A cable for doing this is included in the HE-XCK and HE-CPK
programming kits.) The OCS will install as a device once plugged in. Drivers for it are normally found
automatically by the Windows operating system as long as an Internet connection is established.
Otherwise, the drivers may be loaded from the
Demo -> Communications Drivers
https://hornerautomation.com/support -files
t h
A p r i l 2 4 , 2 0 2 0
HE-XEC Ethernet Utility -> HTTP Web Server
section of the support files page on the website:
Figure 7.2 – USB Programming Connector
MAN1029-08-EN_EXL10_UserManual
P a g e 58 | 191