Configuration Register Details - Registers That Lose Programming In Sleep State - Texas Instruments CC2500 TK Manual

0x25: FSCAL1 – Frequency Synthesizer Calibration
Bit Field Name
7:6 Reserved
5:0 FSCAL1[5:0]
0x26: FSCAL0 – Frequency Synthesizer Calibration
Bit Field Name
7 Reserved
6:0 FSCAL0[6:0]
Bit Field Name
7 Reserved
6:0 RCCTRL1[6:0]
Bit Field Name
7 Reserved
6:0 RCCTRL0[6:0]
32.2 Configuration Register Details – Registers that Lose Programming in SLEEP State
0x29: FSTEST – Frequency Synthesizer Calibration Control
Bit Field Name
7:0 FSTEST[7:0]
Bit Field Name
7:0 PTEST[7:0]
Reset R/W Description
R0
32 R/W Frequency synthesizer calibration result register. Capacitor array
(0x20) setting for VCO coarse tuning.
Fast frequency hopping without calibration for each hop can be done
by calibrating upfront for each frequency and saving the resulting
FSCAL3, FSCAL2 and FSCAL1 register values. Between each
frequency hop, calibration can be replaced by writing the FSCAL3,
FSCAL2 and FSCAL1 register values corresponding to the next RF
frequency.
Reset R/W
R0
13 (0x0D) R/W
0x27: RCCTRL1 – RC Oscillator Configuration
Reset R/W
0 R0
65 R/W
(0x41)
0x28: RCCTRL0 – RC Oscillator Configuration
Reset R/W
0 R0
0 R/W
(0x00)
Reset R/W Description
89 R/W For test only. Do not write to this register.
(0x59)
0x2A: PTEST – Production Test
Reset R/W Description
127 R/W Writing 0xBF to this register makes the on-chip temperature sensor
(0x7F) available in the IDLE state. The default 0x7F value should then be
written back before leaving the IDLE state.
Other use of this register is for test only.
SWRS040C
Description
Frequency synthesizer calibration control. The value to use in
this register is given by the SmartRF
Description
RC oscillator configuration.
Description
RC oscillator configuration.
CC2500

Studio software [5].
Page 80 of 89