Table of Contents
Advertisement
DWR-980 Wireless AC1200 4G LTE Router
with VDSL2 Support, Gigabit Ethernet Ports,
2 FXS Ports, and USB Port
User Manual
You can specify the following parameters:
Parameter
Enable
Name
IP address
Interface
Remote IP address
MTU
Allow traffic GRE →
LAN
Remote GRE interface
subnet
Remote subnet
After configuring all needed settings, click the APPLY button.
To edit the parameters of an existing tunnel, in the Tunnels section, select the relevant tunnel in
the table. On the opened page, change the needed parameters and click the APPLY button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
Tunnel settings
Move the switch to the right to enable the GRE tunnel.
Move the switch to the left to disable the GRE tunnel.
A name of the tunnel for easier identification. You can specify any
name.
The IP address of the GRE tunnel interface with the mask of the
subnet.
From the drop-down list, select a WAN connection through which
the tunnel will pass. Select the Default gateway value to use the
default WAN connection.
Enter the IP address of the remote subnet VPN gateway.
The maximum size of units transmitted from the remote host to the
router.
Move the switch to the right to allow GRE tunnel users access
devices in the remote local subnet.
Static route settings
The subnet and mask of the remote GRE interface.
Remote LAN IP addresses
To specify the IP address and mask of the remote local subnet, click
the ADD SUBNET button, and in the line displayed, enter the
needed value.
To remove a subnet, click the Delete icon ( ) in the corresponding
line.
).
Page 172 of 372
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
