D-Link DWR-980 User Manual page 164

DWR-980 Wireless AC1200 4G LTE Router
with VDSL2 Support, Gigabit Ethernet Ports,
2 FXS Ports, and USB Port
User Manual
You can specify the following parameters:
Parameter
Enable
Name
IP version
Dynamic IPsec
Type
Remote host
Remote identifier
13 0-9, A-Z, a-z, space, !"#$%&'()*+,-./:;<=>?@[\]^_`{|}~.
General Settings
Move the switch to the right to enable the tunnel.
Move the switch to the left to disable the tunnel.
A name for the tunnel for easier identification. Use digits, Latin letters
(uppercase and/or lowercase), and other characters available in the US
keyboard layout. 13
An IP version.
Move the switch to the right to allow a remote host with any public IP
address to connect to the router via IPsec protocol. Such a setting can
be specified for one IPsec tunnel only. Connection requests via this
tunnel can be sent by a remote host only.
Select an identification method for the remote host (router) from the
drop-down list:
Address: The remote host is identified by its IP address.
•
FQDN: The remote host is identified by its domain name.
•
The drop-down list is displayed if the Dynamic IPsec switch is
moved to the left.
Enter the remote subnet VPN gateway IP address if the Address
value is selected from the Type drop-down list.
Enter the remote subnet VPN gateway domain name if the FQDN
value is selected from the Type drop-down list.
The field is available for editing if the Dynamic IPsec switch is
moved to the left.
A remote host identifier to establish connection over IPsec with
particular hosts only. To establish connection, DWR-980 remote
identifier value should correspond to the local identifier value
specified in the settings of the remote host. Use an IP address of a host
or subnet, the value %any (all IP addresses), a domain name, or
certificate CN. By default, the value specified in the Remote host
field is used.
Page 164 of 372
Configuring via Web-based Interface
Description