D-Link DWR-980 User Manual page 141

DWR-980 Wireless AC1200 4G LTE Router
with VDSL2 Support, Gigabit Ethernet Ports,
2 FXS Ports, and USB Port
User Manual
On the opened page, you can specify the following parameters:
Parameter
Name
Enable
MAC address
MTU
VPI
VCI
Encapsulation
ATM / PTM
A name for the interface for easier identification. You can specify
any name.
To enable the use of the ATM or PTM interface, move the switch to
the right.
To disable the use of the ATM or PTM interface, move the switch
to the left.
For the PTM section only.
A MAC address assigned to the interface. This parameter is
mandatory if your ISP uses MAC address binding. In the field, enter
the MAC address registered by your ISP upon concluding the
agreement.
To set the MAC address of the network interface card (of the
computer that is being used to configure the router at the moment)
as the MAC address of the WAN interface, move the Clone MAC
address of your NIC switch to the right. When the switch is
moved to the right, the field is unavailable for editing.
To set the router's MAC address, click the RESTORE DEFAULT
MAC ADDRESS button (the button is available when the switch is
moved to the right).
The maximum size of units transmitted by the interface.
For the ATM section only.
Virtual Path Identifier. The valid range is from 0 to 255.
For the ATM section only.
Virtual Circuit Identifier. The valid range is from 32 to 65535.
For the ATM section only.
Select LLC or VCMUX from the drop-down list.
Page 141 of 372
Configuring via Web-based Interface
Description