11
SERVICE WORK ON THE CHASSIS
11.22
Removing the seat
11.23
Mounting the seat
11.24
Removing the air filter box lid
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever to angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
101789-11
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101798-10
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower it at the
rear and simultaneously it push forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixation.
Guideline
Remaining screws, chassis
101730-01
Condition
The air filter box lid is secured.
–
Remove screws
101795-10
–
Pull off the air filter box lid in area
101796-10
.
4
.
5
M10
.
1
.
1
sideways and remove it toward the front.
A
M14x1.5
80 Nm (59 lbf ft)
60 Nm
Loctite
(44.3 lbf ft)
p. 34)
M6
10 Nm (7.4 lbf ft)
44
®
2701