Table of Contents
Advertisement
14
ELECTRICAL SYSTEM
14.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
14.2
Installing the battery
x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Disconnect the negative (minus) cable
–
Pull back the positive terminal cover
the battery.
–
Detach rubber band
–
Lift the battery out.
101814-10
x
Main work
–
Insert the battery into the battery compartment with the terminals facing to the
front.
(All SX‑F models)
Battery (YTX4L-BS) (
(XC‑F)
Battery (YTX5L-BS) (
–
Reconnect rubber band
–
Connect positive cable
Guideline
Screw, battery terminal
Info
Contact disks
with the claws facing down.
–
Slide positive terminal cover
101815-10
–
Connect negative cable
Guideline
Screw, battery terminal
Info
Contact disk
with the claws facing down.
Finishing work
–
Mount the seat. (
p. 44)
of the battery.
1
and disconnect the positive (plus) cable of
2
from the bottom.
3
p. 89)
p. 89)
.
1
.
2
M5
must be mounted between screws
A
over the positive terminal.
6
.
3
M5
must be mounted between screw
A
p. 44)
69
2.5 Nm
(1.84 lbf ft)
and cable sockets
4
5
2.5 Nm
(1.84 lbf ft)
and cable socket
4
5
Advertisement
Table of Contents
