www.ti.com
Figure 2-3
shows the system setup for the INA219_Test_Board schematic. D1 is an LED that indicates whether
the INA219 Test Board is receiving power. Jumpers allow the selection of the power source as well as
configuration of A0 and A1. Connector T4 allows the connection of the shunt and bus voltages.
SBOU074E – JANUARY 2009 – REVISED JULY 2023
Submit Document Feedback
Figure 2-3. INA219_Test_Board Schematic
Copyright © 2023 Texas Instruments Incorporated
INA219EVM Rev A Model User's Guide and Software Tutorial
System Setup
5
Need help?
Do you have a question about the INA219EVM and is the answer not in the manual?