Ssh - Planet Networking & Communication WGS-4215-8P2S User Manual

4.9.5.2 SSH

Configure SSH on this Page. This Page shows the Port Security status. Port Security is a module with no direct configuration.
Configuration comes indirectly from other modules - the user modules. When a user module has enabled port security on a port,
the port is set-up for software-based learning. In this mode, frames from unknown MAC addresses are passed on to the port
security module, which in turn asks all user modules whether to allow this new MAC address to forward or block it. For a MAC
address to be set in the forwarding state, all enabled user modules must unanimously agree on allowing the MAC address to
forward. If only one chooses to block it, it will be blocked until that user module decides otherwise.
The SSH Settings and Information screens in
The page includes the following fields:
Object
 SSH Service
 Login Authentication List
 Enable Authentication List
 Session Timeout
 Password Retry Count
 Silent Time
Buttons
: Click to apply changes.
: Click to disconnect telnet communication.
Figure 4-9-22 & Figure 4-9-23
Figure 4-9-22 SSH Settings Page Screenshot
Description
Disable or enable SSH service
Select login authentication list from this drop-down list
Select enable authentication list from this drop-down list
Set the session timeout value
Set the password retry count value
Set the silent time value
236
User's Manual of WGS Managed Series
appear.