Replacement
seca 674, 675
2 Display
Please be sure to observe the sequence listed below when removing/fitting the parts!
2.1 Removing the display
Undo the four screw connections (T, Fig. 6) at the bottom of the operating and display
unit first.
Now carefully lift the printed operating and display unit (A1, Fig.6).
Detach the plug-in connections between the modular cable and the NEC2 display
(S1, Fig.5).
2.2 Replacing the membrane keypad / NEC 2 display
To replace the membrane keypad (U), NEC2 display (V) you need to undo the four
screw connections (T, Fig. 6) at the bottom of the operating and display unit first.
Now carefully lift the printed operating and display unit (A1, Fig. 6).
The plug-in connector (X) connects the membrane keyboard (U) with the NEC2
display (V).
Carefully detach this connection! You can now take off the printed operating and
display unit (A1, Fig. 6).
The membrane keyboard (U) is glued in place and must be replaced with a new one.
Detach the plug-in connections between the modular cable and the NEC2 display
(S1).
Unsolder the battery/accumulator battery connections (C1), if applicable.
Unscrew the NEC2 display from the board holder (D1, Fig. 6)
and remove the NEC2 display.
Proceed in the reverse order for reassembling
When aligning the display components refer to cabling diagram 08-02-06-058.
U
Figure 5: Detail cableplan 08-02-06-058 NEC2 Display/radio module/membrane keyboard
08.02.2013/MRE
X
S1
Seite 8 (9)
W
V
C1
30-34-00-859_E1