Example For Gravity Factor Setting [374|703|634|644|656|664|674|676|684|284|954]; Summary Of A Typical Gravity Factor Setting Sequence [374|703] - Seca 378 Service Manual

Maintenance
2.3.1 Example for Gravity Factor Setting
[374|703|634|644|656|664|674|676|684|284|954]
The current gravity factor shown on the display is 98135 kg mm/s².
The target gravity factor is 98150 mm/s².
In this example, you must switch the scale to incrementing mode to set the
gravity factor. When the tare/hold key has been pressed (for more than 1.5
seconds), "inc" starts flashing.
Now start to increase the value by 5 mm/s² (by briefly pressing the tare/hold
key). After this has been repeated three times, the value 98150 mm/s² appears
on the display.
Complete the gravity factor setting procedure as described above.
2.3.2 Summary of a Typical Gravity Factor Setting Sequence
[374|703]
Action carried out by the user
The scale is switched off.
Press the tare/hold key and keep it
pressed while simultaneously pressing
the start key.
Release both keys.
Press the tare/hold key for more than 1.5
seconds.
18 seconds have passed and no key has
been pressed.
Briefly press the tare/hold key (for less
than 1.5 seconds).
Press the tare/hold key for more than 1.5 "dec" appears on the display (flashing)
14.11.12/RLEU/ARI/MRE
Result
No values or characters on the display.
The contents of the calibration counter
flash on the display for 18 seconds.
The contents of the calibration counter
flash on the display for 18 seconds.
The system switches to adjustment
selection mode and "CAL" flashes on the
display.
The scale switches off.
"GAL" flashes on the display.
19/40
seca
30-34-00-812c