Table of Contents
Advertisement
MAP 5000
Mounting an edge protection profile
Element
1
2
2.4
Checking the AC connection
1.
2.
3.
4.
5.
Warning!
After ensuring the AC connection is functional, turn the AC breaker off before continuing the
!
installation process.
2.5
Installing the power supply and power supply accessories
Caution!
Debris
!
Damage to the power supply due to debris during the installation is possible.
–
1.
2.
3.
Bosch Sicherheitssysteme GmbH
1
Description
cut-outs
edge protection profile
Ensure that the AC circuit breaker switch is off.
Connect the AC line to the AC terminal block.
Switch the AC breaker on.
Verify that the circuit breaker does not trip and that appropriate line voltage is present on
the fused side of the AC terminal block.
Switch the AC breaker off and continue with the rest of the installation.
To prevent damage to the power supply during installation, ensure that the supplied
protective dust cover label is on top of the power supply before installing it.
Slide the left side of the power supply against the flange on the left side of the enclosure
back wall.
Align the cut-out on the right side of the power supply.
Secure the power supply to the enclosure back wall with the supplied hardware in the
following order: external tooth washer, washer, hex nut
Installation manual
Installation | en
19
1
2
2018.08 | 23 | F.01U.168.332
Advertisement
Table of Contents
