Installing The Icp-Com-If Relay Module - Bosch MAP 5000 Instruction Manual

MAP 5000
2.
Ferrite core
2.13

Installing the ICP-COM-IF relay module

The ICP-COM-IF relay module can be mounted on the hinged mounting plate or the mounting
rails of the MAP control panel enclosure.
A clearance of approx. 15 mm is required on either side for subsequent wiring. The terminal
plugs can be unplugged laterally.
1.
2.
Bosch Sicherheitssysteme GmbH
Position the ferrite core as close as possible to the enclosure knockout inside the
enclosure.
Attach the carrier plate of the ICP-COM-IF relay module in the holes provided in the
hinged mounting plate or the mounting rails.
Use the screw provided to secure the carrier plate to the bottom rail.
Installation manual
Installation | en 37
2018.08 | 23 | F.01U.168.332