Taurus RB10.5 Pro Assembly And Operating Instructions Manual page 22

Step 6: Mounting the covers and pedals
1. Mount the seat (69) on the main frame (1) with four screws (112) and four washers (16).
2. Screw the left pedal (51L) to the left crank (48L) by turning the pedal (51L) counterclockwise.
3. Screw the right pedal (51R) to the right crank (48R) by turning the pedal (51R) clockwise.
⚠ CAUTION
Make sure to screw in the pedals completely.
4. Place the front and rear covers (5) on the front and rear stabilisers (4 & 2) and mount each cover
(5) with three screws (39).
5. Place the covers (114 & 115) under the backrest (119) and mount each cover (114 & 115) with
one screw (38) and two scres (39).
6. Now hand tighten all screws.
Step 7: Connecting the equipment to the mains supply
࣑ ATTENTION
The equipment must not be connected to a power board, otherwise it cannot be guaranteed
that the equipment will be supplied with sufficient power. Technical errors can result.
NOTICE
L
The mains plug should only be used if the battery charge is insufficient.
Connect the adaptor (124) to the unit and then plug the adaptor (124) into a wall socket that complies
with the specifications in the chapter on electrical safety.
The adaptor included in the package is used to charge the battery, which is installed inside the
console.
Please notice the following precautions, otherwise the performance of the battery may decrease:
1. If the battery is fully discharged, it must be recharged for 8 to 10 hours.
2. If the battery is partially discharged, it must be charged for 1 to 4 hours.
3. If you do not plan to use the device for a longer period of time, charge the battery completely
before storing the device.
4. The fully charged battery must be recharged after one month of storage.
22
RB10.5