Sensor-Independent Settings; System - Xylem YSI pH 1310P Operation Manual

TruLab pH 1310
ba76156e01 03/2014
ter in the measured value display and press the <F1>/[menu] or <MENU/
ENTER> key. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
Menu item
Man. temperature
Temperature unit
Resolution mV
Stability control
Reset
7.3

Sensor-independent settings

7.3.1 System

To open the Storage & config menu, press the <F1__>[Menu] key in the mea-
sured value display. After completing the settings, switch to the measured
value display with <M>.
Default settings are printed in bold.
Menu item
System / General /
Language
System / General /
Beep
System / General /
Illumination
System / General /
Contrast
Possible Description
setting
-25 ... +25 Entry of the manually determined tem-
... +130 °C perature. For measurements without
temperature sensor only.
°C Temperature unit,
°F degrees Celsius or degrees Fahrenheit.
All temperatures are displayed with the
selected unit.
0.1 Resolution of the mV display
1
On Switches on or off the automatic stability
Off control during measurement (see sec-
tion Stability control (AutoRead) &
HOLD function, page 22 )
- Resets all sensor settings to the delivery
condition (see section 7.4.1 R
THE MEASUREMENT SETTINGS
Possible set-
ting
Deutsch
English
(further)
On
Off
Auto
On
Off
0 ... 50 ... 100 %
, page 45).
Description
Selects the menu language
Switches on/off the beep on
keystroke
Switches the display illumina-
tion on/off
Changing the display contrast
Settings
ESETTING
43