Sensor-Independent Settings; System - Xylem WTW Multi 9430 Operating Manual

Multi 9430
Menu item
System / General / Language
System / General / Audio signal
System / General / Brightness
System / General / Tempera-
ture unit
System / General / Stability
control
System / Interface / Baud rate
System / Interface / Output for-
mat
System / Interface / Decimal
separator
System / Interface / Output
header
System /Clock function
System /Service information
System /Reset
ba75966e04 04/2015
9.6

Sensor-independent settings

9.6.1 System

To open the Storage & config menu, press the <ENTER_> key in the measured
value display. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
Setting
Deutsch
English
(more)
on
off
0 ... 10 ... 22
°C
°F
on
off
1200, 2400, 4800,
9600, 19200
ASCII
CSV
Dot (xx.x)
Comma (xx,x)
Date format
Datum
Time
-
Explanation
Selects the menu language
Switches on/off the beep on key-
stroke
Changes the display brightness
Temperature unit,
degrees Celsius or degrees Fahren-
heit.
All temperature values are displayed
with the selected unit.
Switches on or off the automatic sta-
bility control during measurement
(see section 9.6.3 A
UTOMATIC
, page 96 )
LITY CONTROL
Baud rate of the USB Device inter-
face
Output format for data transmission
For details, see section 11 T
, page 107
TING DATA
Decimal separator
Output of a header for Output format:
CSV
Settings of time and date.
For details, see section 3.8.5
E 2
XAMPLE ON NAVIGATION
, page 25
THE DATE AND TIME
Hardware version and software ver-
sion of the meter are displayed.
Resets the system settings to the
default values.
For details, see section 9.7.2 R
TING THE SYSTEM SETTINGS
Settings
S -
TABI
-
RANSMIT
: S
ETTING
-
ESET
, page 100
95